Make sure the Mastercode has been enabled before trying to disable it. If programming is unsuccessful, the “X” pattern will flash three times, and you will hear three beeps. Press Lock symbol once.If programming is successful, the Checkmark will illuminate and you will hear one beep. Press and HOLD the Program button until the Checkmark symbol illuminates (about 5 seconds).2. If you immediately hear fi ve beeps and see the Checkmark flash five times, the Mastercode is enabled.Disabling and Deleting the Mastercode1. Make sure switch #3 is on, and press the Program button once. Attempt the procedure again, making sure to enter the same new Mastercode in step 3 and 5.7. Make sure the Mastercode has not already been programmed. Press Lock symbol onceIf programming is successful, the Checkmark will illuminate and you will hear one beep.If programming is unsuccessful, the “X” pattern will flash three times, and you will hear three beeps. How do I enable/delete the mastercode on my Smartcode touchscreen?Įnabling and Setting the MastercodeProgramming timeout: If the screen is not pressed for 20 seconds, the system will time out (indicated by three beeps and the “X” pattern flashing three times), and you will need to restart the procedure.1. If you don’t immediately hear three beeps and see the keypad fl ash green three times, the Mastercode is disabled.Note: The lock will time out after five seconds. Attempt the procedure again, making sure to enter the same Mastercode in steps 3 and 5.7. Press Lock button once.If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Press and HOLD the Program button until the keypad Flashes green (about 5 seconds).2. If you hear three beeps andNote: The lock will time out after five seconds.Disabling and Deleting the Mastercode1. Attempt the procedure again, making sure to enter the same new Mastercode in step 2 and 4.6. Press and HOLD the Program button until the keypad flashes green (about 5 seconds).2. After reading the articles above you should be able to figure out which of your codes are conflicting based on the keypad layout and there after you should be able to your codes using LUM and the stock device handler without any issues.How do I enable/delete the mastercode on my Smartcode?Įnabling and Setting the MastercodeProgramming timeout: If no button is pressed for five seconds, the system will time out and you will need to restart the procedure.1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |